Collar - simple and elegant - extra strong

Stainless steel collar - simple and elegant, EXTRA STRONG - lockable with a special Allen key

The EXTRA STRONG version of our BDSM collar from the Simple and Elegant series. All collars are individually handcrafted and adjusted according to your dimensions. Equipped with a hinge in the back and, in this case, an invisible closure at the front. They can be locked with a special Allen key.

The front of this choker is made similarly to the hinge on the back. The closure is done using an Allen key, which operates the Allen screw hidden in the middle section. The screw in the middle part cannot fall out, as is often the case with locking screws attached to the outside. It is operated via a small hole on the bottom.

The effect of our stainless steel restraints can be felt simply by the weight of the material. Thanks to the precise craftsmanship, they also fit perfectly and are therefore suitable for longer periods of wear. For the advanced and serious submission, which at the same time dresses in elegance.  

Dimension guide

In order to create the stainless steel strips precisely, we need your individual and exact dimensions. For the measurement it makes sense to have two people. Please proceed as follows and enter the measurements in centimeters and millimeters (cm, mm) in the field provided in the order mentioned below (1) / 2) / 3) ):

collar

1) SCOPE

Measure the neck circumference using a flexible tape measure. Keep your head straight while measuring and place the tape measure at the level of the larynx. Please note this circumference value under 1).

2) DIAMETER WIDTH

For this you will need two hardcover books. Hold these with the spines of the books at the sides of your neck. Make sure that the books only touch the skin of the neck, but do not press it. Both books must be aligned parallel to each other. Now use a ruler to measure the distance between the two spines of the book. Alternatively, use a caliper. Write down the value under 2).

3) DIAMETER DEPTH

For this you will need two hardcover books. You hold these with their spines against your neck, both at the front and at the back. Make sure that the books only touch the neck, but do not dent it. It is important that the books are at the same height, namely at the thickest part of the neck (larynx). Both books must also be aligned parallel to each other again. Now use a ruler to measure the distance between the two spines of the book. Alternatively, use a caliper. Write down the value under 3).